admin> help
CLI provides a number tools for device configuration.
There are two modes, which represents a different
possibilities for viewing\setting data. Operational mode
is a default mode. Operational mode provides only commands
which does not changing data. Configuration mode provides
a full set of possibilities for data manipulation. If data
manipulation and\or device configuration are needed -
enter 'configure' command to enter in configure mode.
If you need a help - press TAB for showing
available commands/pathes/values or press '?' to
display additional information about current completions
Follows commands are available in operational mode:

show - show data (in config mode also)
dir - show existing saved configuration
configure - enter to config mode
call - execute special command in subsystem
exit - exit from cli (in config mode exit to user mode)

Follows commands are available in configuration mode:

set - set data in accordance with model tree
del - delete data in accordance with model tree
apply - configure device
end - go to top level of model tree
edit - navigation in model tree
up - go to upper level from current
save - save current configuration to file
load - load configuration from file
remove - delete user configuration file
store - store user configuration file
op - get available commands from operational mode in conf

ig mode

revert - revert last command

ping - ICMP ECHO

d - 'top' command synonym
.. - 'up' command synonym
/ - 'top' command synonym

Отображаются режимы и команды CLI