EcoNAT allows hot reconfiguration without interrupting operation. However, there are times when you need to restart the equipment. For example, you have to reboot EcoNAT to apply the version of the embedded software (firmware), as the result of update.
Use reboot command for restarting EcoNAT.
After entering the command, the system will ask you to confirm a reboot: «Confirm (y / N)» Press [y] to confirm, otherwise the restart will not occur.
To turn off the EcoNAT (for example, in the case of physically moving the device to another site), used
poweroff command. After entering the command, the system prompts you to confirm the shutdown: «
Confirm (y/N)». Press
[y] to confirm, otherwise the shutdown will not occur.
